7.13 Setting end stops

• Fit end stops provisionally, so that the carriages do not drop out

7.14 External radar

• Mark radar position on outside of door with radar drilling templates and drill, or use built-in radar in cladding (see installation instructions for built-in radar)
• Fit radar and draw in cable on inside

7.15 Hanging door leaves

• Draw in rubber seals on door leaves and secure (drawing in is simplified by moistening the rubber seal with soapy water)
• Hanging door leaves (if present: etched record logo must be legible from outside)
• Connect door leaves with hangers of carriages

7.16 Adjusting door leaves

• First set height
• Distance behind of locking bar = 50mm (important when using a VRR). The centre buffer of the left, central carriage serves simultaneously as setting gauge.
• All 4 carriages must be aligned
• The door leaves must not be too close to the brush profile
• Align door leaves slightly V-shaped
• Tighten fixing screws (door leaf suspension with carriage) firmly
• Tighten door leaf fixing screw (door leaf with door leaf suspension) firmly

Check counter wheels: they must not be in line and it must be possible to turn them easily!

7.17 Fixing end stops

The door can be mechanically locked from inside in this condition. For this purpose the door leaves must be closed by hand and fixed with the two end stops in this position. (Tighten only screw below)

• Aligning and fixing end stops

7.18 Attaching drive module

• Open door leaves approx. 400 mm
• Attach drive module
• Centre drive module provisionally
• Fix slidebars, remove slidebar lock if necessary (cable ties) if they interfere with the motion
• Centre module with door leaf exactly with respect to side screens
• When using a lock, check engagement of locking bolts and move VRR if necessary
• Fix module left and right with slotted angle:
  • First tighten centre screw (1) (M6 x 16)
  • Level with Allen screw (2) (M6 x 12)
  • Fix with socket-head hex. screw (3) (M6 x 10 and washer)
• Fix lock (if provided) on track support profile P1302 with 2 additional screws M6 x 10mm and tongue nuts
• If there is no locking device, an additional fixing will be necessary (contained in # 016.005.000)

7.19 Checking toothed belt tension

• Check toothed belt tension and tighten if necessary:
  • Guide pulley support must be parallel to track (no distortion)
  • Tighten guide pulley support firmly

7.20 Checking door leaves by hand

• Move door leaves by hand and check for easy running

7.21 Options

(If not already completed as preliminary work in workshop)

7.22 Cable layout

• A slot is provided for the mains cable above the header
• AGTA cabling below header in slot provided

7.23 Connecting electrical units

Connect BDE, ELS, radar, etc. according to chapter Cable Routing page 50 and chapter.

• Wiring diagram page 51 and fit cable cover.
• The power regulations must be obeyed when the BDE (factory data capture unit) is used in multiple combinations!
• For record 16 STA-UL: Before applying the mains voltage to the power supply NET16-UL, the installer has to ensure that the mains voltage selector switch on the power supply is switched to the correct position (115V / 230V).
• The mains power connection has to be done via the mains cord supplied with the pedestrian sliding door operator (see also schematic LS.016.001A chapter 0 page 51). Proper grounding has to be applied. Only permanent wiring is allowed with this pedestrian sliding door operator.
• The local installation codes must always be followed.

7.24 Protection wings

• Fit any protection wings

7.25 Final mechanical test

• Manual door opening satisfactory over the entire opening range
• No abnormal noises present
• All screws tight