Safety Tips
- The device cannot be used for purposes other than its intended use. All other uses cannot be guaranteed by the manufacturer of the sensor.
- The manufacturer of the door system is responsible for carrying out a risk assessment and installing the sensor and the door system in compliance with applicable national and international regulations and standards on door safety.
- The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate adjustments of the sensor.
- Only trained and qualified personnel may install and setup the sensor.
- The warranty is invalid if unauthorized repairs are made or attempted by unauthorized personnel.
- Always test the good functioning of the installation before leaving the premises.
- The door control unit and the door cover profile must be correctly earthed.
Installation Tips
- Avoid vibrations.
- Do not cover the laser window.
- Avoid moving objects and light sources in the detection field.
- Avoid the presence of smoke and fog in the detection field.
- Avoid condensation.
- Avoid exposure to sudden and extreme temperature changes.
- Keep the sensor permanently powered in environments where the temperature can descend below -10°C.
- Remove the laser window protection before the teach-in and the commissioning of the sensor.
- Do not remove the laser window protection when building works are still in progress on site.
Maintenance Tips
- Clean the laser window with compressed air.
- If needed, wipe only with a soft, clean and damp microfibre cloth.
- Do not use dry or dirty towels or aggressive products to clean the laser window.
- Avoid direct exposure to high pressure cleaning.
Device Description
- 1 - cover
- 2 - push button
- 3 - DIP-switch
- 4 - master-slave connector
- 5 - main connector
- 6 - angle adjustment screw
- 7 - plug
- 8 - clamp
- 9 - cap and screws (flexible kit)
- 10 - flexible tube
- 11 - lock screw
- 12 - laser head
- 13 - laser window
- 14 - laser window protection
- 15 - positioning aids
- 16 - mounting base
- 17 - master-slave cable
- 18 - power cable
LED Signals
- Relay 1 / Relay 2
- LED flashes slowly: Indication state.
- LED is off: Normal operation / no detection.
- LED flashes x times: Error codes (refer to specific manual details).
- LED flashes red-green: Calculation in progress. Exit the zone and wait.
- LED flashes quickly: Active state or alert.