14. Cover
The cover and back plate are manufactured in clear anodized aluminium. The end plates are made of silver or black painted steel sheet.
14.1 Fitting and removing the cover
The cover is slid over flanges in the back plate so that the ridges fit in the grooves. Snap on the fill cover into the slot for the output shaft. Secure the cover with screws.
Installation Check: When properly installed and adjusted, attach the product label,
which includes the CE mark, on the right side of the lower part of the operator cover.
Apply the ASSA ABLOY logotype to the cover.
For Sweden (SE) Markets Only: Apply the SITAC label next to the product label.
14.2 Cover piece kit
| Part Number | Description |
|---|---|
| CL-719.5 | Single door |
| CL-1433 | Double door |
15. Signage
Check that all required signage is applied and intact. Mandatory indicates that the signage is required by European directives and equivalent national legislation outside the European Union.
- A Product label: Mandatory.
- B Emergency break-out: Mandatory, if approved for escape route.
- C ASSA ABLOY Entrance Systems door sticker: Mandatory according to ASSA ABLOY Entrance Systems brand instructions, European directives, and equivalent national legislation outside the European Union, to highlight the presence of the glass.
- D Supervision of child: Applied to both sides of the door. Mandatory according to national regulations. Recommended if the risk analysis shows use by children.
- E Operator designed for disabled people: Recommended, if applicable (applied to both sides of the door).
- F Activation by disabled people: Recommended, if applicable.
- G No entry: Identifying one-way traffic. Mandatory in GB and US, if applicable (not included in the product).
- H Automatic door: Standard text signage.
- J Keep clear: Standard safety text signage.
-
K
SITAC label: Mandatory in SE (Sweden).
Additional text: Ersätter lås med fallkolv till typgodkända slagdörrar enl. förteckning. Skydd mot olyckor vid rörliga anordningar.