8.1 Pushing Installation with PUSH-arm
This arm system is delivered with drive arm, telescopic part, and door fitting. It is specifically designed for operators installed on the wall on the opposite side of the door swing and is approved for fire door applications.
Dimensions & Frame Depth
| Configuration | Frame Depth | Dimension A | Dimension B |
|---|---|---|---|
| High Performance | 8 1/4” (210 mm) | See chart below | - |
| LE Performance | 2 3/8” (60 mm) | - | - |
| Extension | 3 3/4” (95 mm) | - | - |
| Standard | 7 5/8” (194 mm) | - | - |
Extension Parts
- 345 mm extension: Art. No. 173005BK/SI
- 230 mm extension: Art. No. 173004BK/SI
- Joint part: Art. No. 173191
Reveal Specifications (Dimension A)
| Reveal Range (A) | Configuration Requirement |
|---|---|
| 0 - 100 mm (0 - 115 mm alt) | None (Standard arm) |
| 100 - 215 mm (115 - 250 mm alt) | Telescopic part L = 345 mm |
| 215 - 305 mm (250 - 305 mm alt) | Extension L = 230 mm + joint part |
8.2 Pulling Installation with PULL-arm
This arm system is delivered with drive arm, guide shoe, and door fitting.
Configurations
| Model | Art. No. | Dimensions | Compatibility |
|---|---|---|---|
| PULL | 1008401BK/SI | A = -20 to 130mm B = 95/210mm |
Standard |
| PULL-220 | 1011998BK/SI | A = -20 to 65mm B = 95mm |
Only for LE Performance |
| PULL-600 | 1014729BK/SI | A = -20 to 230mm B = 250/420mm |
Only for High Performance |
8.3 Pulling Installation with PAS-arm
This arm system consists of main arm, slide track, roller guide, and shaft adaptor. It is designed for combinations of doors and jambs (walls) where the total reveal from the wall line to the door leaf does not exceed 130 mm.
- DIN-R: Art. No. 1007476BK/SI
- DIN-L: Art. No. 1007247BK/SI
Max Reveal: 0 - 130 mm
8.4 20 mm Extension
Extension 20 mm for PULL/PAS and lower mounting of slide track profile.
8.5 Pushing Installation with PULL-arm
This arm system consists of main arm, slide track, guide shoe, and shaft adapter. It handles wall thicknesses not exceeding approx. 114 mm. Dimensions correspond to an opening angle of 90-100°.
8.6 Drive Shaft Extension Kits
| Size | Article Number |
|---|---|
| 20 mm | See Manufacturer (1008396BK/SI)* |
| 50 mm | See Manufacturer (1008398BK/SI)* |
| 70 mm | 1008400BK/SI |
* Article numbers 1008396/1008398/1008400 listed sequentially in source text against sizes.