1. Introduction
These instructions contain important information regarding the operation and maintenance of the GEZE Powerdrive automatic sliding door systems.
1.1 Symbols and Illustrations
Warning notices are used in these instructions to warn you of personal injury and property damage. Always read and observe these warning notices. Observe all the measures that are marked with the warning symbol and warning word.
Danger to persons. Non-compliance may result in death or serious injuries.
Danger to persons. Non-compliance can result in minor to medium injuries.
Additional Symbols
| Symbol | Meaning |
|---|---|
| Important Note | Information about avoiding property damage. |
| Additional Information | Useful additional information. There is no danger to persons or property. |
| Action Symbol | This means you have to do something. If there are several actions, keep to the given order. |
| BOBO (Break-out) | The door leaves and side panels are equipped with a break-out function. |
| No BOBO | No break-out function; means the function is not possible for break-out doors. |
1.2 Product Liability
In accordance with the manufacturer's liability for their products as defined in the German “Produkthaftungsgesetz” (Product Liability Act), the information contained in this user manual (product information and proper use, misuse, product performance, product maintenance, obligations to provide information and instructions) is to be noted and followed. Failure to comply releases the manufacturer from his statutory liability.
1.3 Special Cases
In certain cases, deviations from the information given in this user manual may occur. Examples include:
- Special wiring
- Special function settings (parameters)
- Special software
Please contact the service technician responsible for further information.
1.4 More Detailed Information
Information for commissioning and maintenance can be found in the wiring diagram and in the installation instructions for the various automatic sliding doors.
1.5 Terms
- Activation device inside (KI)
- Push button, switch or movement detector for activating the door drive. The activation device is located within the room enclosed by the door. Active in “Automatic” and “Exit only” modes. No function in “Night/Locked” and “Off” modes.
- Activation device outside (KA)
- Push button, switch or movement detector for activating the door drive. The activation device is located outside the room enclosed by the door. Active in “Automatic” mode. No function in “Exit only”, “Night/Locked” and “Off” modes.
- Activation device authorised (KB)
- Access control function (e.g., key switch or card reader) used by authorised persons to activate the door drive. Active in all modes: “Automatic”, “Exit only”, “Night/Locked” and “Off”.
- Opening safety sensor (SIO)
- Presence detector (e.g., active infrared light sensor) for protecting the swinging range of the door in the opening direction. The sensor secures the secondary closing edge.
- Closing safety sensor (SIS)
- Presence detector (e.g., active infrared light sensor) for protecting the swinging range of the door in the closing direction. The sensor secures the main closing edge on the inside and outside.
- Emergency stop
- Self-locking switch with which immediate stopping of the door drive can be triggered in case of danger. The door drive remains in its current position until the user releases the emergency stop switch again.
- Emergency lock
- When the emergency lock is triggered, the door is closed and locked. The activations and safety devices are deactivated during the closing process.
- Reset
- Push button for restarting the drive after the operating voltage has been switched on or after a fire alarm has been terminated. When pressed, the self-retention integrated in the drive is activated.