Next section
Next page: →Chapter 1: General Information
1.1 Owner's Manual
This Owner's manual applies to dormakaba ED50/ED100/ED250 swing door operators supplied with a fine cover.
1.2 ED50/ED100/ED250 with Fine Cover Installation
The ED50/ED100/ED250 with fine cover must be installed on an interior building surface.
Exterior Door Use
To insure proper suitability for exterior door use, the following topics must be addressed in the context of the door application setting:
- Site-specific use factors such as high wind conditions and/or building pressure.
- Door width, height, weight, and usage patterns.
- Observable prevailing conditions at the opening under which the operator is expected to perform. In some instances, this may require increased force settings to counteract these conditions.
- Door mounted presence sensors.
When attempting to overcome these forces, it is strongly suggested that door mounted presence sensors be employed to enhance pedestrian safety through the opening.
1.3 Manual Storage
This document must be kept in a secure place, and accessible for reference as required. If the door system should be transferred to another facility, insure that this document is transferred as well.
1.4 Dimensions
Unless otherwise specified, all dimensions are given in inches (“).
1.5 Symbols Used in This Manual
This symbol warns of hazards which could result in personal injury or threat to health.
Draws attention to important information presented in this document.
Chapter 2: To Our Customers
We are pleased that a dormakaba ED50/ED100/ED250 swing door system has been selected for this installation. dormakaba designed, tested and built the system to provide many years of service.
The purpose of this manual is to familiarize you with your ED50/ED100/ED250 swing door system. It is essential that you "know your system" and that you recognize the importance of maintaining your door system in compliance with industry standards for safety.
It is your responsibility as owner and caretaker of the equipment, to inspect the operation of your door system on a daily basis as outlined in Chapter 4, Safety information checklist to insure that it is safe for use by your customers and employees.
Should the door fail to operate as prescribed in the Safety information checklist or at any other time for any reason, do not attempt to repair or adjust the ED50/ED100/ED250 swing door system!
Call your local authorized dormakaba USA, Inc. distributor for repair.
The distributor's AAADM certified technicians are trained to service the ED50/ED100/ED250 swing door system using the dormakaba USA, Inc. Installation and Setup and Troubleshooting Instructions, and in accordance with ANSI/BHMA safety standards.
2.1 Service Availability
dormakaba USA, Inc. has a nationwide network of authorized distributors for sales, installation and service of its products.
2.2 Compliance with Industry Standards for Safety
Your ED50/ED100/ED250 swing door system was designed to the latest ANSI/BHMA operating and safety standards. In order to insure the continued safe operation of the door, it is important that:
- Proper decals and labels be applied and maintained on your doors (Chapter 7).
- If decals and labels have been removed, or cannot be read, contact your local authorized dormakaba USA, Inc. distributor for replacement decals or labels.