4 Important Information
4.1 Intended Use
The ASSA ABLOY SL300 is an automatic sliding door operator developed to facilitate entrances to buildings and within buildings.
The ASSA ABLOY SL300 is designed to be surface-mounted to the wall or a beam. It is easy to install for both new construction and retrofit application, and it can be adapted to a wide range of door requirements. It is to be installed indoors where it is suitable for almost all types of external and internal sliding doors.
The door is designed to offer continuous use, a high degree of safety and maximum lifetime. The system is self-adjusting to the effects caused by normal variations in the weather conditions and to minor friction changes caused by e.g. dust and dirt.
This manual contains the necessary details and instructions for the installation, maintenance and service of the Sliding Door Operator ASSA ABLOY SL300.
Save these instructions for future reference.
4.2 Safety Precautions
Be sure to complete a risk assessment according to "Guide for installers of Powered Pedestrian Sliding Doors" (PRA-0004) and fill in the "Site Acceptance Test" (PRA-0005) before taking the door into operation.
To avoid bodily injury, material damage and malfunction of the product, the instructions contained in this manual must be strictly observed during installation, adjustment, repairs and service etc.
Training is needed to carry out these tasks safely. Only technicians that are trained by an ASSA ABLOY Entrance Systems educated trainer should be allowed to carry out these operations.
4.3 Electronic Equipment Reception Interference
The equipment may generate and use radio frequency energy and if not installed and used properly, it may cause interference to radio, television reception or other radio frequency type systems.
If other equipment does not fully comply with immunity requirements, interference may occur. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Re-orient the receiving antenna.
- Relocate the receiver with respect to the equipment.
- Move the receiver away from the equipment.
- Plug the receiver into a different outlet so that equipment and receiver are on different branch circuits.
- Check that protective earth (PE) is connected.
If necessary, the user should consult the dealer or an experienced electronics technician for additional suggestions.
4.4 Environmental Requirements
ASSA ABLOY Entrance Systems products are equipped with electronics and may also be equipped with batteries containing materials which are hazardous to the environment.
Disconnect power before removing electronics and battery and make sure it is disposed of properly according to local regulations (how and where) as was done with the packaging material.