14. Signage
Check that all required signage is applied and intact. Mandatory indicates that the signage is required by European directives and equivalent national legislation outside the European Union.
- Product label: Mandatory
- ASSA ABLOY Entrance Systems door sticker: Mandatory according to ASSA ABLOY Entrance Systems brand instructions, European directives, and equivalent national legislation outside the European Union, to highlight the presence of the glass.
- Supervision of child (applied to both sides of the door): Mandatory according to national regulations. Recommended, if the risk analysis shows use by children.
- Local product label: Mandatory
15. Accessories
15.1 Lock
- Install the lock (11) to the beam (1), adjust the position of the lock (11).
- Tighten the screws (35).
Note! If the lock (11) could not lock the door, adjust the screws (37).
15.2 Battery
Fix the battery unit (38) to the beam (1) with screws (14).
15.3 Cover set
- Slide the cover locks (25) to the cover (27), then tighten screws (26), make sure that the cover locks (25) and the door stops do not interfere.
- Fix the end plates (28) with screws (29) to the end of the cover (27).
- Hang up the cover set (13) to the beam (1).
- Insert the detachment guards (30) to the cover (27).
- Tighten screws (31) on the cover locks (25) onto the beam (1) to secure the cover (27).
- When opening the cover set (13) and needed to hold the cover set (13), use the tool (32) to fix on the middle of cover set (13).
15.4 Operation mode selectors
The door functions are set with operation mode selector. The operation mode selector is available with 5 positions (plus RESET).
15.4.1 PSK-6U - Modes
OPEN, AUTO PARTIAL, AUTO, EXIT and OFF modes can be obtained.
| Mode | Description |
|---|---|
| OPEN | The door is permanently open. The door can be moved by hand (e.g., for window cleaning). All activation units are disconnected. |
| AUTO PARTIAL | Two-way traffic, AUTO PARTIAL is obtained. The door can be opened partially with the inner and outer activation units and with a key switch (if fitted). |
| AUTO | Two-way traffic, normal operation of the door. The door can be opened fully with the inner and outer activation units and with a key switch (if fitted). |
| EXIT (ONE WAY) | One-way traffic passage from inside only. The door is normally locked if an electromechanical locking device has been fitted. The door can only be opened with the inner activation unit or with a key switch (if fitted). |
| OFF | The door is closed and locks (if an electromechanical lock is fitted). The door cannot be opened with inner and outer activation units. The door can be opened partially with a key switch (if fitted). |
| RESET |
Turn the key clockwise to the position “R” (six o’clock) and insert a narrow object in the small hole on the operation mode selector and push briefly. The operator will RESET, then turn the key counter-clockwise back to the requested setting. The operator will start-up again, the doors will return to closed position with low speed (if operation mode selection is not OPEN). If the operator is equipped with battery unit, the operator will test the battery unit by opening with battery after the doors have closed with low speed (if operation mode selection is not OPEN or OFF).
Note! The key cannot be removed in the "R" position.
|
15.5 Electrical opening with the battery unit
Used if a door is required to be opened by means of a rechargeable battery unit and remain in this position in the event of power failure. The battery can be monitored.