Manufacturer Information
| Manufacturer | ASSA ABLOY Entrance Systems AB |
|---|---|
| Address | Lodjursgatan 10, SE-26144 Landskrona, Sweden |
| Product Type | ASSA ABLOY SW100 |
This product is to be installed internally.
Electrical Specifications
| Mains Supply |
100-240V AC +10/-15%, 50/60Hz Mains fuse max 10A (building installation) |
|---|---|
| Power Consumption | Max. 75 W |
| Auxiliary Voltage | 24 V DC, max. 400 mA (max. 1000 mA including lock) |
| Mains Fuse (Internal) | 2 x T 6,3 AH/250V |
| Electro-mechanical Locking Device | Selectable: 12 V DC (max. 500 mA) or 24 V DC (max. 250 mA) |
Installation Note: The mains supply shall be installed with protection. An all-pole mains switch with isolating capability of Category III, at least 3 mm between contacts, shall be installed according to local regulations. These articles are not provided with the door.
Mechanical Dimensions & Capacity
| Door Size / Inertia (J) |
PUSH arm system: Size 4 (J = 45 kgm²) PULL arm system: Size 1 (J = 16 kgm²) |
|---|---|
| Inertia Calculation | Inertia = Door weight × (Door width)² / 3 |
| Door Opening Angle |
PUSH arm: 80° - 110° (with reveal 0 - 305 mm) PULL arm & Sliding PUSH arm: 80° - 110° (with reveal -20 - 130 mm) |
Operational Performance
| Opening Time (0° - 80°) | Variable between 3 - 6 s |
|---|---|
| Closing Time (90° - 10°) | Variable between 3 - 6 s |
| HOLD Open Time | 1.5 - 30 s |
Safety Warning: If opening or closing time is set to below 3 seconds, it does not meet the requirements of LOW ENERGY. Under these conditions, safety sensors must be installed.
Environmental & Physical Data
| Ambient Temperature | -20 °C to +45 °C |
|---|---|
| Relative Humidity | Max. 85% |
| Drive Unit Weight | 7.1 kg |
| Class of Protection | IP20 |
| Protection (Control Actuators) | IP54 |
Certifications & Approvals
Third party approvals from established certification organizations valid for safety in use, see Declaration of Conformity.
| Complies with | EN 16005, EN 60335-2-103, EN 1634-1 |
|---|---|
| Controlled Door Closing | EN 1154 Table I, size 4 |
4.1 Permitted Door Weight and Door Width
The ASSA ABLOY SW100 complies with the following door weight/width limits represented by the inertia values:
- PUSH arm limits: J = 45 kgm²
- PULL arm limits: J = 16 kgm²
(Refer to official manual diagrams for precise weight vs. width curves).